Jump starter cable
EC5 应急启动线缆——铜导体、带夹就绪、防反接保护
EC5 应急启动线缆通过两个夹子将便携式应急启动电源连接到电池。我们的线缆采用 100% 铜,10 AWG 或 8 AWG,每条引线约 37 cm,配备防反接保护模块,夹子接反时自动切断电路。
- 100% 铜导体,10 AWG 或 8 AWG
- 引线内置防反接保护
- 红色 370 mm / 黑色 340 mm,对折包装以便紧凑零售
- OEM from 5,000 sets
Specification
What you get in one set
两个夹子、两条引线和串联式保护模块。两种线径共用相同的连接器、夹子和长度,因此一个外箱可混装而不改变包装。
| Item | 10 AWG | 8 AWG |
|---|---|---|
| Cross-section | 5.26 mm² | 8.37 mm² |
| Conductor | 100% copper | 100% copper |
| Connector | EC5 | EC5 |
| Lead length | Red 370 mm / black 340 mm | Red 370 mm / black 340 mm |
| Clamps | Insulated battery clamps | Insulated battery clamps |
| Compatibility | 12 V and 16.8 V jump starters | 12 V and 16.8 V jump starters |
| Protection | 防反接自动断电 | 防反接自动断电 |
| OEM MOQ | 5,000 sets | 5,000 sets |
Length is measured pin to clamp. Tell us the pack you are building for and we will confirm the set that matches it before a sample is cut.
Packing design
为什么红黑引线长度不同
买家在每次首次电话沟通中都会问到这一点,所以值得直说:两根引线长度不一,是包装决策,不是裁切错误。
- 两条引线有意不等长——红色 370 mm,黑色 340 mm。
- 长度差让这对引线能对折平放入紧凑的零售袋中,因此吸塑盒或彩盒可以更小。
- 更小的内盒意味着每个出口外箱可装更多套,从而降低包装成本和单件运费。
- 两条引线均由机器按固定长度裁切,因此外箱中每套的尺寸都一致。
What it saves on a full carton
A folded pair with a 30 mm offset sits flatter in the pouch than two equal leads, so the pouch, the inner box and the export carton all shrink with it. On a full container the difference is paid once in packing material and again in freight, which is why the offset has stayed in the drawing.
If your packaging needs equal leads, say so at the sample stage. The length is a cutting setting, not a tooling change.
Gauge
8 AWG 还是 10 AWG:多出的铜买到什么
两种线径都适配同一个 EC5 插头和相同的夹子。差异只会在启动的头几秒显现。
10 AWG — 5.26 mm²
The volume choice for small petrol engines, motorcycles, garden equipment and packs sold into retail at a price point. Lighter, cheaper to ship, and enough for a warm engine.
8 AWG — 8.37 mm²
About 59% more copper than 10 AWG. Lower resistance, so less voltage drop reaches the starter. The choice for diesel, large-displacement petrol and cold-climate packs, where a thin lead is what makes a good pack look weak.
Sizing a lead is a current-and-time question, not a numbers-up question: the cable only has to survive the crank, and the crank only lasts seconds. We will quote both gauges against your pack so you can compare landed cost rather than copper weight.
Protection
Reversed clamps cut the circuit instead of the pack
If the clamps are connected to the wrong terminals, the module cuts the circuit instead of letting current flow. Correct the connection and the cable works normally again. There is no fuse to replace and no button to reset — the protection is in the lead, so it travels with the product and does not depend on the user reading a manual.

Inside the build
从裁切到外箱之间的五项检查
夹子、线径和线缆长度是买家可以手工核验的三项。生产线上的所有安排都确保这三项在包装前被检查。
- 导体按长度裁切,然后剥线并压接到 EC5 端子。
- 压接高度在生产线上检测——压接松动在启动电流下就是发热点。
- 保护模块串联焊接,然后给组件套上护套。
- 每套都进行导通检查,并让保护断电装置触发复位一次。
- 装上夹子,折叠成对并装袋,然后按外箱数量装箱。
Related
同一工厂,同样的铜材工艺规范
EC5 套装与我们其他线缆组件共用同一条压接、测试和包装产线。
Buyer questions
Three things buyers ask first
这条线缆能适配我的应急启动电源吗?
它使用 EC5 连接器,适配采用 EC5 的 12 V 和 16.8 V 便携式应急启动电源。下单前请检查您电池组上的插座:EC5 是带防呆键的插头,因此采用其他连接器的电池组无法对插。请发送电池组型号,我们会在您下样品单前确认匹配性。
10 AWG 和 8 AWG 有什么区别?
8 AWG 的铜截面积为 8.37 mm²,而 10 AWG 为 5.26 mm²,多出约 59%。在相同长度下,这意味着电阻更低,在启动的那几秒内电压降更小,这对柴油发动机和大排量汽油发动机尤为重要。在小排量发动机使用的电池组上,10 AWG 是更经济的选择。
如果我接反夹子会怎样?
如果夹子接错端子,模块会切断电路而不是让电流流过。纠正连接后,线缆即可恢复正常工作——无需更换保险丝,也无须按复位按钮。这保护了应急启动电源电池组,也就是套件中最昂贵的部分。
Building a jump starter kit?
Send the pack model and the annual volume and we will come back with the gauge, the clamp and the packing that fit it. wangyazhong@hengchangtech.com