
USB Type-C Connectors
USB 2.0 to USB4, 240 W rated. Plugs, receptacles and PCB-mount parts in the pin counts your design calls for.
View productTwo owned plants make everything on this page: one assembles fibre patch cords, one builds connectors and copper cable assemblies. Pick a family below, or send the drawing or part number and we will confirm which plant runs it, what tooling already exists and the lead time.
Board-side parts bought on specification: pin count, plating, current rating and the routing your PCB actually needs. Samples come from stock; custom plating and packing follow the drawing.

USB 2.0 to USB4, 240 W rated. Plugs, receptacles and PCB-mount parts in the pin counts your design calls for.
View product
Surface-mount receptacles for USB 3.0, USB 3.2 PD and USB4 over twisted pair or coaxial. 29 part numbers, straight and right-angle.
View product
High-current DC connectors, 20 A to 45 A, 10-16 AWG, solder cups or PCB pins, anti-spark option.
View product
Spring-loaded battery contacts, 1–6 positions, gold-plated, SMD or DIP, with a white vertical housing option.
View product
Flat blade contacts for battery packs, 3–12 positions, low-profile SMD bodies that fit under a cover.
View product
Horizontal barrel jacks, through-hole or SMD, with or without a shield can, for adapter-powered devices.
View product
Vertical barrel jacks in ten body heights from 10.5 to 17.5 mm, so the plug meets the board from above.
View product
Red/black AM and gold-look blue ECS bullet connectors, 20 A and 40 A, 180° wire exit, solder termination.
View product
30 and 60 size bullet connectors for RC packs and drones: 20 A on 16 AWG, 35 A on 12 AWG, 180° solder exit.
View product
Sealed and board-mount multi-contact blocks: power contacts plus a signal grid in one housing, flanged for a panel or soldered to the board.
View product
Every part we run, photographed: USB-C receptacles and plugs, battery and pack connectors, board-level parts.
View productFinished cords tested end to end, with insertion loss, return loss and continuity reported per batch. Fibre, copper and high-current leads are assembled on the same floor as the connectors they use.

SC, LC, FC and ST in single-mode and multimode, 0.5 m to 50 m, tested for insertion and return loss before packing.
View product
Stainless-steel micro-tube inside the jacket. For trays, risers and plant floors where a standard cord gets crushed.
View product
Replacement EC5 leads with battery clamps for 12 V and 16.8 V jump starters. 100% copper, 10 or 8 AWG, reverse-polarity safe.
View productMost enquiries start with a drawing, a sample or a part number rather than a product name. Tell us the application and we will say which of the two factories it belongs to, what tooling already exists and what the realistic lead time is.
We quote against your specification rather than a catalogue number. Include the application, the annual volume and any test report the buyer requires.